FixVault
Home › Chevrolet › 2016 › Volt Premier › Repair and Diagnosis › Hybrid/Electric Powertrain › Cooling Systems › Hybrid/EV System Heating And Cooling › Repair Instructions › Drive Motor Generator Control Module Coolant Pump Hose Replacement › Installation Procedure

Installation Procedure

    Fig 1: Radiator Surge Tank And Coolant Hose
    GM4091119Courtesy of GENERAL MOTORS COMPANY
  1. Install Coolant Hose (2)
  2. Install Clamp (3) BO-38185  pliers
  3. Move the radiator surge tank (1) in front direction (arrow) to their original position.
    4. Fig 2: Surge Tank Bolt
    GM4091143Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Fastener Caution

  4. Install Radiator Surge Tank Bolt (1) and tighten 9 N.m (80 lb in)
  5. Raise the vehicle.
    6. Fig 3: Clamp And Coolant Hose
    GM4091142Courtesy of GENERAL MOTORS COMPANY
  6. Install Coolant Hose (1)
  7. Install Clamp (2) BO-38185  pliers
  8. Install Front Wheelhouse Liner Front Wheelhouse Liner Replacement (Left Side)Front Wheelhouse Liner Replacement (Right Side)
  9. Lower the vehicle.
  10. Fill the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling 
About FixVault