Removal Procedure
WARNING:
Before conducting any repair to this high voltage cooling system, it is necessary to determine/verify whether no high-voltage system faults exist. If high-voltage faults exist, follow published DTC diagnostics/repair procedures prior to performing any cooling system repairs. Failure to correct High Voltage Faults before working on the high voltage cooling system could result in personal injury or death.
- Turn the Vehicle Power Off, remove all keyless entry transmitters from the vehicle and secure in a place outside the vehicle.
- Drain the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove Front Wheelhouse Liner Front Wheelhouse Liner Replacement (Left Side)Front Wheelhouse Liner Replacement (Right Side)
- Clamp (1) BO-38185 pliers
- Coolant Hose (1)
- Lower the vehicle.
- Radiator Surge Tank Bolt (1)
- Move the radiator surge tank (1) in engine direction (arrow) and in top direction until the lower hose is accessible.
- Loosen Clamp(3)BO-38185 pliers
- Remove Coolant Hose(2)