Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Camshaft Position Sensor Seal |
| Fuel Injector Lower O-ring Seal |
| Fuel Injector Upper O-ring Seal |
| Fuel Tank Pressure Sensor Seal |
| Primary Fuel Tank Module Cam Lock Ring |
| Primary Fuel Tank Module Seal Ring |
| Secondary Fuel Tank Module Cam Lock Ring |
| Secondary Fuel Tank Module Seal Ring |
| Throttle Body Gasket |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Accelerator Pedal Position Sensor Bolt | 9 N.m (80 lb in) |
| Air Cleaner Inlet Duct to Air Cleaner Assembly Clamp | 4 N.m (35 lb in) |
| Air Cleaner Inlet Duct to Throttle Body Retaining Clamp | 4 N.m (35 lb in) |
| Air Cleaner Outlet Duct Clamp | 2 N.m (18 lb in) |
| Air Cleaner Outlet Duct to Air Cleaner Upper Housing Retaining Clamp | 2 N.m (18 lb in) |
| Air Cleaner to Chassis Retaining Fastener | 10 N.m (89 lb in) |
| Camshaft Position Sensor to Engine Front Cover Retaining Bolt | 9 N.m (80 lb in) |
| Coolant Temperature Sensor | 20 N.m (15 lb ft) |
| Crankshaft Position Sensor Fastener | 25 N.m (18 lb ft) |
| Front Fuel/Brake/EVAP Pipe/Line Assembly Protection Plate Bolt | 22 N.m (16 lb ft) |
| Fuel Filler Tube to Chassis Retaining Bolt | 9 N.m (80 lb in) |
| Fuel Rail Ground Strap to Intake Manifold Retaining Bolt | 10 N.m (89 lb in) |
| Fuel Rail to Intake Manifold Retaining Bolt | 10 N.m (89 lb in) |
| Fuel Tank Filler Hose Clamp | 3.5 N.m (31 lb in) |
| Fuel Tank Heat Shield | 5.5 N.m (49 lb in) |
| Fuel Tank Strap Fastener | 50 N.m (37 lb ft) |
| Heated Oxygen Sensor | 42 N.m (31 lb ft) |
| Ignition Coil Assembly to Rocker Cover Retaining Bolt | 12 N.m (106 lb in) |
| Ignition Coil to Ignition Coil Assembly Retaining Bolt | 12 N.m (106 lb in) |
| Knock Sensor to Engine Block Retaining Bolt | 25 N.m (18 lb ft) |
| Manifold Absolute Pressure Sensor Fastener | 5 N.m (44 lb in) |
| Rear Fuel/Brake Pipe Assembly Stone Guard Retaining Nut | 4 N.m (35 lb in) |
| Rear Fuel/Brake/EVAP Pipe/Line Assembly Stone Guard Retaining Nut | 4 N.m (35 lb in) |
| Spark Plug (NEW Cylinder Head Only) | 20 N.m (15 lb ft) |
| Spark Plug (Non NEW Cylinder Head) | 15 N.m (11 lb ft) |
| Throttle Body Bolt | 10 N.m (89 lb in) |
| Throttle Body Fastener | 12 N.m (106 lb in) |
| Throttle Body Nut | 10 N.m (89 lb in) |