Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Drivetrain and Front Suspension Cradle Front Bolt | |
|
100 N.m (75 lb ft) |
|
90 - 105 Degrees |
| Drivetrain and Front Suspension Cradle Rear Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 Degrees |
| Electric Belt Drive Rack and Pinion Steering Gear Nut | |
|
55 N.m (41 lb ft) |
|
150 - 165 Degrees |
| Lower Control Arm Bolt | |
|
100 N.m (74 lb ft) |
|
30 - 45 Degrees |
| Lower Control Arm Nut | |
|
100 N.m (74 lb ft) |
|
90 - 105 Degrees |
| Stabilizer Shaft Bolt | |
|
22 N.m (16 lb ft) |
|
30 - 45 Degrees |
| Steering Knuckle Nut | |
|
35 N.m (26 lb ft) |
|
30 - 45 Degrees |
| Steering Linkage Outer Tie Rod Nut | |
|
35 N.m (26 lb ft) |
|
30 - 45 Degrees |
| Transmission Mount Strut Bolt | |
|
100 N.m (74 lb ft) |
|
120 - 135 Degrees |
| Transmission Mount Strut Bolt to Transmission Rear Mount | |
|
100 N.m (74 lb ft) |
|
120 - 135 Degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Exhaust Muffler Insulator Nut | 2.5 N.m (22 lb in) |
| Front Compartment Insulator Bolt "lb in" spec shown | 2.5 N.m (22 lb in) |
| Front Compartment Splash Shield Bolt | 2.5 N.m (22 lb in) |
| Front Tire Front Air Deflector Fastener | 2.5 N.m (22 lb in) |
| Front Wheelhouse Liner Bolt | 2.5 N.m (22 lb in) |
| Rear Tire Front Air Deflector Fastener | 2.5 N.m (22 lb in) |
| Rear Wheelhouse Liner Bolt | 2.5 N.m (22 lb in) |
| Rear Wheelhouse Liner Nut | 2.5 N.m (22 lb in) |
| Stabilizer Shaft Link Nut | 65 N.m (48 lb ft) |
| Underbody Rear Air Deflector Bolt | 2.5 N.m (22 lb in) |
| Underbody Rear Air Deflector Nut | 2.5 N.m (22 lb in) |