Fastener Specifications

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application	Specification
Application	Metric (English)
Front Lower Control Arm Bushing Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	30 - 45 degrees
Front Lower Control Arm Bushing Bolt and Nut
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 degrees
Front Shock Absorber Upper Nut
First Pass:	35 N.m (26 lb ft)
Final Pass:	30 - 45 degrees
Front Stabilizer Shaft Bolt
First Pass:	22 N.m (16 lb ft)
Final Pass:	30 - 45 degrees
Front Wheel Bearing And Hub Bolt
First Pass:	90 N.m (66 lb ft)
Final Pass:	60 - 75 degrees
Lower Control Arm to Steering Knuckle Nut
First Pass:	35 N.m (26 lb ft)
Final Pass:	30 - 45 degrees
Steering Gear Outer Tie Rod to Steering Knuckle Nut
First Pass:	35 N.m (26 lb ft)
Final Pass:	30 - 45 degrees
Front Suspension Strut Mount Nut	45 N.m (33 lb ft)
Front Stabilizer Shaft Link Nut	65 N.m (48 lb ft)
Steering Gear Outer Tie Rod to Steering Knuckle Nut	35 N.m (26 lb ft)

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English)
Front Wheel Speed Sensor Bolt	6 N.m (53 lb in)