FixVault
Home › Chevrolet › 2017 › Express 2500 LS, 2.8L Eng VIN 1 › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Wheel Speed Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Front Brake & Hub Assembly
    GM885802Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Refer to Brake Dust Warning .

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the tire and wheel. Tire and Wheel Removal and Installation (Without Dual Rear Wheels)Tire and Wheel Removal and Installation (With Dual Rear Wheels)
  3. Remove the brake rotor (2) shown on the 1500 Series. Front Brake Rotor Replacement (JH9)Front Brake Rotor Replacement (JH6)
    4. Fig 2: Wheel Speed Sensor Cable And Connectors
    GM913362Courtesy of GENERAL MOTORS COMPANY
  4. Remove the wheel speed sensor (WSS) cable mounting clip from the knuckle.
  5. Remove the WSS cable mounting clip from the upper control arm.
  6. Remove the WSS cable mounting clip from the frame attachment point.
  7. Remove the WSS cable electrical connector.
    8. Fig 3: Wheel Speed Sensor Mounting Bolt
    GM924317Courtesy of GENERAL MOTORS COMPANY
  8. Remove the WSS mounting bolt.
    9. Fig 4: Removing Wheel Speed Sensor From Hub/Bearing Assembly
    GM887991Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the bore. Prying will cause the sensor body to break off in the bore.

  9. Remove the wheel speed sensor (5) from the hub/bearing assembly (4) shown on the 2500/3500 Series.
About FixVault