FixVault
Home › Chevrolet › 2017 › Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas › Repair and Diagnosis › Body & Frame › Windows › Fixed And MOVEABLE Window System › Repair Instructions › Rear Sliding Window Module Replacement › Removal Procedure

Removal Procedure

    Fig 1: Bolt And Regulator
    GM3346336Courtesy of GENERAL MOTORS COMPANY
  1. Open the rear sliding window approximately 3.5 in (89 mm).
  2. Remove the bolt (1) from the rear sliding window regulator and cables (2).
  3. Pull forward on the regulator and cables (2) to release it from the module.
  4. Remove the body rear panel insulator. Refer to Body Rear Panel Insulator Replacement .
    5. Fig 2: Rear Sliding Window Module Nuts
    GM3346338Courtesy of GENERAL MOTORS COMPANY
  5. Remove the rear sliding window module nuts (1).
  6. Disconnect the rear sliding window electrical connector from the module (2).
  7. Remove the rear sliding window module assembly from the vehicle.
About FixVault