FixVault
Home › Chevrolet › 2017 › Spark LS, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 10 (Antilock Brake System) › Repair Instructions › Rear Wheel Speed Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2028202

    Install the wheel speed sensor to the vehicle.

  2. Connect the electrical connector (1).
  3. GM2189141

    Install the wiring harness (2) retainers (3) to the TOP SIDE of brake hose (4), using the marking points of old wiring harness.

  4. Install the wiring harness (2) to the NEW body retainer (1).
  5. GM2028189

    Install the wheel speed sensor (1) to the steering knuckle.

  6. Install the wiring harness (3) at the bracket (4).
    7. CAUTION:

    Refer to Fastener Caution .

  7. Install the wheel speed sensor screw (2) and tighten to 6 N.m (53 lb in).
  8. GM2189142

    Check the correct installation position of the wiring harness (1). The wiring harness MUST be routed on top of the brake hose. If necessary adjust retainers (2) to the marking positions on the brake hose.

  9. Apply tension to the wiring harness (1) between the retainers (2) for the correct routing.
  10. Push down the brake hose by hand, to assure the correct installation position.
  11. Install the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
About FixVault