Installation Procedure
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Install the parking brake cable (2) to the electronic parking brake control module (3).
- Install the parking brake cable connection cover (1).
Install the electronic parking brake control module (2) to the vehicle.
- Insert the electronic parking brake control module mounting tang into the rubber mounting grommet (3).
- Install the 2 electronic parking brake control module nuts (1), and tighten to 9 N.m (80 lb in).
- Connect the electronic parking brake control module wiring harness.
- Install the wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Connect the battery. Refer to Battery Negative Cable Disconnection and Connection .
- Program the electronic parking brake control module. Refer to Control Module References .
- Tension the parking brake cable. Refer to Parking Brake Cable Adjuster Enabling .
CAUTION:
Refer to Fastener Caution .