Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, 2017 Chevrolet Suburban, and 2017 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
- Place the ignition switch in the OFF position.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Thoroughly clean the area around the electronic brake control module (EBCM) of all dirt and debris.
- Disconnect the EBCM electrical connector.
- Remove the EBCM bolts (1).
- Carefully separate the EBCM (1) from the brake pressure modulator valve (BPMV) by pulling straight away from the BPMV.
NOTE:
Do not attempt to pry or lever against the EBCM.