FixVault
Home › Chevrolet › 2017 › Traverse LS Base › Repair and Diagnosis › Accessories & Equipment › Collision/Avoidance › Object Detection System And Pedestrian Protection System › Diagnostic Information and Procedures › DTC B1008: Calibration Data Not Programmed › Circuit/System Verification

Circuit/System Verification

    NOTE:

    Do not diagnose this DTC if set in history

  1. Ignition ON.
  2. Verify that DTC B101E 42 is not set.
    • If the DTC is not set 
  3. Verify that DTC B1008 is not set.
    • If DTC is set 
    1. Calibrate the front camera module. Refer to Front View Camera Module Learn .
    2. Verify the DTC does not set.
      • If the DTC sets, replace the frontview camera module.
      • If the DTC does not set
    3. All OK.
    • If the DTC is not set 
  4. All OK.
About FixVault