FixVault
Home › Chevrolet › 2017 › Traverse LS Base › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions › Repair Instructions › Ignition Coil Replacement - Bank 1 › Installation Procedure

Installation Procedure

    Fig 1: Ignition Coil View - Bank 1
    GM860797Courtesy of GENERAL MOTORS COMPANY
  1. Install the ignition coil(s).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the ignition coil bolt(s).

    Tighten 

    Tighten the bolt(s) to 10 N.m (89 lb in).

    3. Fig 2: Ignition Coil Electrical Connector - Bank 1
    GM1860397Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (4).
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
About FixVault