FixVault
Home › Chevrolet › 2018 › Camaro SS, 2D Convertible, Automatic Trans › Repair and Diagnosis › Brakes › Parking Brake System › Repair Instructions › Electronic Parking Brake Control Module Replacement › Removal Procedure

Removal Procedure

  1. Block the drive wheels.
  2. Disable the parking brake cable adjuster. Parking Brake Cable Adjuster Disabling 
  3. Place the ignition in the OFF position.
  4. Raise and support the vehicle. Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (ZL1)Lifting and Jacking the Vehicle (Convertible)
  5. Exhaust Muffler - Remove - Exhaust Muffler Replacement (LGX, Coupe)Exhaust Muffler Replacement (LGX, Convertible)Exhaust Muffler Replacement (LT1, LT4, Coupe)Exhaust Muffler Replacement (LT1, LT4, Convertible)Exhaust Muffler Replacement (LTG, Coupe)Exhaust Muffler Replacement (LTG, Convertible)
  6. GM2833696Courtesy of GENERAL MOTORS COMPANY

    Remove the electronic parking brake control module bolts (1).

  7. Position the electronic parking brake control module to access the electrical connector.
  8. Disconnect the electronic parking brake control module electrical connector.
  9. GM2833700Courtesy of GENERAL MOTORS COMPANY

    Disconnect the parking brake intermediate cable nut (1).

  10. GM3105162Courtesy of GENERAL MOTORS COMPANY

    Remove the electronic parking brake control module bracket bolts (1).

  11. Separate the electronic parking brake control module from the bracket.
  12. GM2833704Courtesy of GENERAL MOTORS COMPANY

    Maneuver and remove the electronic parking brake control module (1).

About FixVault