FixVault
Home › Chevrolet › 2018 › Cruze LS, Automatic Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions › Repair Instructions › Fuel Pressure Sensor Replacement - Fuel Feed Pipe › Removal Procedure

Removal Procedure

WARNING:

Diesel/Gasoline Vapors Warning

WARNING:

Safety Goggles and Fuel Warning

  1. Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection
  2. Relieve the fuel pressure:Fuel Pressure Relief 
  3. Lower the fuel tank, to get enough space to remove the fuel pressure sensor - fuel feed pipe. Refer to Fuel Tank Replacement .
  4. GM4091454

    Disconnect the fuel tank fuel feed pipe (4) from the fuel tank fuel pump module (1). Refer to Plastic Collar Quick Connect Fitting Service .

  5. Close all connections with EN-6015  plugs.
  6. Disconnect the electrical connector.(2)
    7. NOTE:

    The fuel pressure sensor can not be replaced individually.

  7. Unclip the fuel tank fuel feed pipe (4) from the fuel tank bracket (5) and the fuel pressure sensor clip (3).
About FixVault