Installation Procedure

NOTE:

Use NEW nuts.

Nut(1) - Loosely install[2x]
NOTE:
Use NEW bolts.

Bolt(1)@Front Lower Control Arm Bushing(2) - Loosely install[2x]
WARNING:
Refer to Torque-to-Yield Fastener Warning .

CAUTION:
Refer to Fastener Caution .

NOTE:
Hold against the nuts (2) to tighten the bolts (1). Use a suitable tool.

Bolt(2) & Nut(1) - Tighten[2x]
1. First Pass: 100 N.m (74 lb ft)
2. Final Pass: 90 to 105 degrees - EN-45059 meter
WARNING:
Refer to Torque-to-Yield Fastener Warning .

CAUTION:
Refer to Fastener Caution .

Bolt(1)@Front Lower Control Arm Bushing(2) - Tighten[2x]
1. First Pass: 100 N.m (74 lb ft)
2. Final Pass:30 to 45 degrees - EN-45059 meter
NOTE:
Support the lower control arm ball joint with a hydraulic jack.

NOTE:
Hold against the hex of the threaded stud to tighten the nut (1). Use a suitable tool.

Install the lower ball joint in the steering knuckle.
Install a NEW nut.(1)

WARNING:

CAUTION:

Nut - Tighten[2x]
1. First Pass:35 N.m (26 lb ft)
2. Final Pass:30 to 45 degrees - EN-45059 meter
If equipped with the front leveling position sensor, connect the electrical connector.
Install the front tire and wheel assembly. Tire and Wheel Removal and Installation
Measure and adjust the wheel alignment. Wheel Alignment Measurement