FixVault
Home › Chevrolet › 2018 › Impala Premier, Gas › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Front Wheel Speed Sensor Replacement › Installation Procedure

Installation Procedure

  1. GM2278446

    Install the wheel speed sensor (1) to the steering knuckle.

  2. Install the harness clip (2) to the steering knuckle.
  3. GM2278445
    CAUTION:

    Refer to Fastener Caution .

    Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).

  4. GM2278444

    Connect the wheel speed sensor electrical connector (1) and secure the connector to the frame.

  5. Install the harness clip (2) to the frame.
  6. Install the harness clips (3) to the lower control arm.
  7. Install the front compartment splash shield. Refer to Front Compartment Splash Shield Replacement .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Perform the Diagnostic System Check - Vehicle .
About FixVault