FixVault
Home › Chevrolet › 2018 › Malibu LS › Repair and Diagnosis › External Pages › Different variant/trim › Section 6 (Hybrid/EV Controls System) › Repair Instructions › Accessory DC Power Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4316483Courtesy of GENERAL MOTORS COMPANY

    Accessory DC Power Control Module (3) - Install

    2. CAUTION:

    Refer to Fastener Caution

  2. Accessory DC Power Control Module Bolt (2) - Install and tighten [2X] 9 N.m (80 lb in)
  3. Accessory DC Power Control Module Nut (1) - Install and tighten [2X] 9 N.m (80 lb in)
  4. GM4316486Courtesy of GENERAL MOTORS COMPANY

    High Voltage Electrical Connector (1) - Connect

  5. Electrical Connector (2) - Connect
  6. Install the retainers. (3)
  7. GM4316679Courtesy of GENERAL MOTORS COMPANY

    Battery Positive Junction Block Cable (3) - Install

  8. Battery Positive Junction Block Cable Bolt (1) - Install and tighten 22 N.m (16 lb ft)
  9. Retainer (2) - Engage
  10. Drive Motor Battery Impact Absorber (4) - Install
  11. GM4316329Courtesy of GENERAL MOTORS COMPANY

    Drive Motor Generator Control Module Tray (2) - Install - Drive Motor Generator Control Module Tray Replacement

  12. Enable the high voltage system. High Voltage Enabling
About FixVault