FixVault
Home › Chevrolet › 2018 › Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Electronic Brake Control Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: EBCM Component Location
    GM3255766Courtesy of GENERAL MOTORS COMPANY
  1. Clean the sealing surfaces of the EBCM and the BPMV with denatured alcohol and allow to dry.
  2. Inspect the EBCM to BPMV gasket for damage and replace, if necessary.
  3. Install the EBCM (1) to the BPMV.
    4. Fig 2: EBCM Bolts
    GM3255759Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Fastener Caution

    NOTE:

    A new EBCM may not have threaded inserts. Refer to the Electronic Parts Catalog and use new self tapping fasteners to form the threads.

  4. Install the EBCM bolts (1) and tighten in a cross pattern to 3 N.m (27 lb in).
  5. Connect the EBCM electrical connector.
  6. Program the EBCM. Control Module References
About FixVault