Programming an Existing or New Control Module

To program an existing or new control module, perform the following procedure:

1. Install the special tool: EL-49642  SPS Programming Support Tool
2. Ignition - On/Vehicle - In Service Mode
3. Access SPS and follow the on-screen instructions for the control module: K71 Transmission Control Module - Programming
   1. After programming is complete, select: MCVM Operations from the Select Function/Sequence Menu (if available) - For more information refer to:Q77 Transmission Control Solenoid Valve Characterization Programming 
   2. After the above step is complete, select: Setup - follow the on screen instructions.
4. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
5. All OK.