FixVault
Home › Chevrolet › 2018 › Spark LS, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 161 (Engine Cooling System) › Repair Instructions › Radiator Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4248358

    Reposition the radiator (1) to the vehicle.

  2. GM4248357

    Install the engine coolant fan shroud (1) to the radiator. Ensure the 4 retaining tabs (2, 3) engage audible.

  3. GM4248356
    NOTE:

    Procedure applies also to the other side.

    Install the 2 radiator upper brackets (2).

    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the 2 radiator upper bracket bolts (1) and tighten to 22 N.m (16 lb ft).
  5. Radiator Inlet Hose@Radiator - Install - Radiator Inlet Hose Replacement 
  6. Radiator Outlet Hose@Radiator - Install - Radiator Outlet Hose Replacement 
  7. Connect the automatic transmission fluid pipes to the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  8. Fill the transmission to the proper level with NEW transmission fluid. Transmission Fluid Drain and Fill
  9. Fill the cooling system. Cooling System Draining and Filling 
  10. Charge Air Cooler Replacement  - Install
About FixVault