Circuit/System Verification

NOTE:

If DTC C0460 58 is set, check all connections for looseness, bent terminals, corrosion, contamination, deterioration, and/or damage before starting Circuit/System Testing.

Ignition ON.
Verify the DTC is not set.
- If the DTC is set
1. Calibrate the K43 Power Steering Control Module. Refer to Power Steering Control Module Calibration
2. Verify the DTC does not set while operating the vehicle within the Conditions for Running the DTC
  - If the DTC sets, replace the steering column assembly.
  - Go to next step: If the DTC is not set
3. All OK.
- Go to next step: If the DTC is not set
All OK.