FixVault
Home › Chevrolet › 2018 › Trax LS, AWD › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Rear Wheel Speed Sensor Replacement › Installation Procedure

Installation Procedure

  1. GM2768795

    Install the wheel speed sensor (1) to the rear suspension knuckle.

  2. GM2768794
    CAUTION:

    Refer to Fastener Caution .

    Install the wheel speed sensor bolt (1) and tighten to 8 N.m (71 lb in).

  3. GM2768792

    Install the wheel speed sensor harness clips (1) to the rear axle.

  4. GM2768790

    Connect the wheel speed sensor electrical connector (1) and install the connector clip to the wheelhouse bracket.

  5. Install the wheel speed sensor harness clip (2) to the wheelhouse panel.
  6. Install the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle .
About FixVault