Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Assembly (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake Pressure Modulator Valve Bracket Nut (1) - Install and tighten 7 N.m (62 lb in) [3x]
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Left Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Right Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Left Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Right Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Connect the EBCM electrical connector.
Bleed the brake system. Antilock Brake System Automated Bleed
Plenum Front Panel - Install - Plenum Front Panel Replacement (LTG LGX)Plenum Front Panel Replacement (LT1 LT4)
Program the EBCM. Control Module References