FixVault
Home › Chevrolet › 2019 › Silverado 1500 LT Trail Boss › Repair and Diagnosis › Body & Frame › Door Locks › Remote Functions › Repair Instructions › Remote Function Actuator Module Replacement (Regular Cab) › Removal Procedure

Removal Procedure

  1. Disable the SIR system. SIR Disabling and Enabling
  2. Remove the front center seat. Front Center Seat Removal and Installation
  3. GM5158756Courtesy of GENERAL MOTORS COMPANY

    Carefully pull the right side rear window lower garnish molding (1) forward around all edges then the middle of the part to disengage the clips from the sheet metal.

  4. After all integral clips are disengaged, lift up and forward to clear the 2 rear end panel brackets that the right side rear window lower garnish molding (1) sits over.
  5. GM5969473Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Front Seat Belt Anchor Plate Tensioner Cover-Right Side (1) - Remove

  6. Front Seat Belt Anchor Plate Tensioner Bolt-Right Side (2) - Remove
  7. GM5163264Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Use a small flat bladed tool to open the right side trim panel bolt cap (1).

  8. Body Lock Pillar Garnish Molding Bolt - Right Side (2) - Remove
  9. Starting at the top and working down with a trim tool, grasp the right side body lock pillar garnish molding (3) and gently pull the panel away from the body to release the retainers.
  10. Body Lock Pillar Garnish Molding-Right Side (3) - Remove
  11. Route the seat belt webbing through the right side body lock pillar garnish molding (3).
  12. GM5161805Courtesy of GENERAL MOTORS COMPANY

    Disconnect the electrical connector.

  13. Release the retaining tabs.
  14. Remote Function Actuator Module (1) - Remove
About FixVault