FixVault
Home › Chevrolet › 2019 › Suburban 3500 HD LS › Repair and Diagnosis › Brakes › Parking Brake System › Repair Instructions › Electronic Parking Brake Control Module Replacement › Installation Procedure

Installation Procedure

  1. Install the electronic parking brake control module and bracket assembly.
  2. GM3610596Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Install the upper electronic parking brake control module bracket bolts (1) and tighten to 9 N.m (80 lb in).

  3. GM3610595Courtesy of GENERAL MOTORS COMPANY

    Install the lower electronic parking brake control module bracket bolt (1) and tighten to 9 N.m (80 lb in).

  4. GM3610594Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    When installing the rear intermediate parking brake cable nut, hold the electronic parking brake control module spindle housing securely to avoid distorting the housing.

    Install the rear intermediate parking brake cable nut (1) and tighten to 6 N.m (53 lb in).

  5. Connect the electronic parking brake control module electrical connector.
  6. Install the spare tire and wheel assembly, if removed.
  7. Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling (With J71) .
  8. Program the electronic parking brake control module. Refer to Control Module References .
About FixVault