FixVault
Home › Chevrolet › 2019 › Trax LS, AWD › Repair and Diagnosis › External Pages › Different car › Section 102 (Disc Brake System) › Repair Instructions › Front Disc Brake Pads Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the contact surfaces of the brake caliper bracket of any corrosion or debris.
  2. GM2375917
    NOTE:

    If installing new disc brake pads, install new disc brake pad springs.

    Install the upper and lower disc brake pad springs (1).

  3. GM2375916
    NOTE:

    Note the location of the brake pad wear sensor for correct installation.

    Install the inner disc brake pad (1).

  4. Install the outer disc brake pad (2).
  5. Position the brake caliper over the disc brake pads and to the caliper bracket.
  6. GM2375915
    CAUTION:

    Refer to Fastener Caution .

    Using a backup wrench to hold the brake caliper guide pin stationary, install the lower brake caliper guide pin bolt (1) and tighten to 40 N.m (30 lb ft).

  7. Install the tire and wheel assembly. Tire and Wheel Removal and Installation
  8. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  9. Slowly release the brake pedal.
  10. Wait 15 seconds, then repeat steps 8 and 9 until a firm brake pedal is obtained. This will properly seat the brake caliper piston and brake pads.
  11. Fill the master cylinder reservoir. Brake Master Cylinder Reservoir Filling
  12. Burnish the brake pads and rotors. Brake Pad and Rotor Burnishing 
About FixVault