FixVault
Home › Chevrolet › 2019 › Volt Premier › Repair and Diagnosis › Hybrid/Electric Powertrain › Cooling Systems › Hybrid/EV System Heating And Cooling › Repair Instructions › Drive Motor Control Module Radiator Inlet Hose Replacement › Installation Procedure

Installation Procedure

  1. Install the drive motor control module radiator inlet hose to the vehicle.
  2. GM4224581Courtesy of GENERAL MOTORS COMPANY

    Coolant Hose(1) - Install

  3. Clamp(2) - Engage - Hose Clamp Replacement Guidelines - Spring Type
  4. GM4091137Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Check the pump and the bracket for the correct original position.

    Install the generator control module coolant pump bracket (1).

    5. CAUTION:

    Fastener Caution

  5. Install the 2 generator control module coolant pump bracket nuts (2) and tighten to 9 N.m (80 lb in).
  6. GM4091149Courtesy of GENERAL MOTORS COMPANY

    Clip(1) - Install[2x]

  7. Coolant Hose(2) - Install
  8. GM4091148Courtesy of GENERAL MOTORS COMPANY

    Coolant Hose(2) - Install

  9. Clamp(1) - Engage - Hose Clamp Replacement Guidelines - Spring Type
  10. Front Headlamp Replacement - Install
  11. Front Wheelhouse Liner Replacement (Left Side)Front Wheelhouse Liner Replacement (Right Side) - Install
  12. Lower the vehicle.
  13. Fill the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling 
About FixVault