Removal Procedure
WARNING:
Before conducting any repair to this high voltage cooling system, it is necessary to determine/verify whether no high-voltage system faults exist. If high-voltage faults exist, follow published DTC diagnostics/repair procedures prior to performing any cooling system repairs. Failure to correct High Voltage Faults before working on the high voltage cooling system could result in personal injury or death.
- Turn the Vehicle Power Off, remove all keyless entry transmitters from the vehicle and secure in a place outside the vehicle.
- Drain the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Front Wheelhouse Liner Replacement (Left Side)Front Wheelhouse Liner Replacement (Right Side) - Remove
Clamp(2) - Loosen - Hose Clamp Replacement Guidelines - Spring Type
- Coolant Hose(1) - Remove
- Lower the vehicle.
Radiator Surge Tank Bolt(1) - Remove[2x]
Move the radiator surge tank (1) in engine direction (arrow) and in top direction until the lower hose is accessible.
- Clamp(3) - Loosen - Hose Clamp Replacement Guidelines - Spring Type
- Coolant Hose(2) - Remove