Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Drive Motor Generator Control Module Cooling Outlet Hose Seal |
| Heater Outlet Hose Fitting O-Ring Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Air Conditioning Evaporator Hose Nut | 22N.m(16 lb ft) |
| Battery Positive and Negative Cable Bracket Nut | 9N.m(80 lb in) |
| Coolant Temperature Sensor | 33N.m(24 lb ft) |
| Drive Motor Battery Coolant Cooler Inlet Hose Nut | 9N.m(80 lb in) |
| Drive Motor Battery Coolant Cooler Nut | 9N.m(80 lb in) |
| Drive Motor Battery Coolant Pump Bracket Stud | 9N.m(80 lb in) |
| Drive Motor Battery Radiator Outlet Hose Bracket Nut | 9N.m(80 lb in) |
| Drive Motor Generator Control Module Cooling Outlet Hose Nut | 9N.m(80 lb in) |
| Drive Motor Generator Control Module Cooling Outlet Hose Bolt | 9N.m(80 lb in) |
| Generator Control Module Coolant Pump Bracket Nut | 9N.m(80 lb in) |
| Heat Shield Nut | 9N.m(80 lb in) |
| Heater Outlet Hose Fitting | 45N.m(33 lb ft) |
| High Voltage Battery Cooling Manifold Inlet Hose Clamp | 2.1N.m(19 lb in) |
| High Voltage Battery Cooling Manifold Outlet Hose Clamp | 2.1N.m(19 lb in) |
| High Voltage Battery Cooling Plate Hose Clamp | 2.1N.m(19 lb in) |
| Radiator Surge Tank Bolt | 9N.m(80 lb in) |
| Radiator Surge Tank Bracket Bolt | 22N.m(16 lb ft) |