Fastener Specifications
WARNING: This page is about a different variant/trim than selected.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Combustion Fuel Injector Seal |
| Emission Reduction Fluid Injector Gasket |
| Emission Reduction Fluid Supply Pump Module Seal |
| Exhaust Gas Recirculation Cooler Gasket |
| Exhaust Gas Recirculation Pipe Gasket |
| Exhaust Gas Recirculation Pipe Seal |
| Exhaust Gas Recirculation Valve Housing Gasket |
| Exhaust Pressure Differential Sensor Hose Clamp |
| Fuel Injection Pump Metering Valve O-ring Seal |
| Fuel Injector Label - Discard if ANY fuel injector is replaced. |
| Fuel Return Line Quick Connect Clip |
| Fuel Tank Fuel Pump Module O-ring Seal |
| Hose Clamp @ Exhaust Gas Recirculation Valve Housing |
| Throttle Body Gasket |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Fuel Feed Pipe Fitting (Fuel Injector to Fuel Rail) | 30 N.m (22 lb ft) |
| Fuel Feed Pipe Fitting (Fuel Pump to Fuel Rail) | 30 N.m (22 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Accelerator Pedal Position Sensor Fastener | 9 N.m (80 lb in) |
| Air Cleaner Assembly Fastener (Bottom Case to Body) | 12 N.m (106 lb in) |
| Air Cleaner Assembly Fastener (Top Case to Bottom Case) | 3.1 N.m (27 lb in) |
| Air Cleaner Outlet Duct Clamp | 3.5 N.m (31 lb in) |
| Camshaft Position Sensor Fastener | 11 N.m (97 lb in) |
| Charge Air Cooler Bolt | 9 N.m (80 lb in) |
| Charge Air Cooler Inlet Duct Clamp | 5 N.m (44 lb in) |
| Charge Air Cooler Inlet Hose Clamp | 5 N.m (44 lb in) |
| Charge Air Cooler Outlet Duct Clamp | 5 N.m (44 lb in) |
| Charge Air Temperature Sensor | 19 N.m (14 lb ft) |
| Chassis Control Module Fastener | 9 N.m (80 lb in) |
| Crankshaft Position Sensor Fastener | 5 N.m (44 lb in) |
| Diesel Fuel Separator Bracket Bolt | 7 N.m (62 lb in) |
| Emission Reduction Fluid Controller Bolt | 5 N.m (44 lb in) |
| Emission Reduction Fluid Injector Nut | 22 N.m (16 lb ft) |
| Emission Reduction Fluid Tank Bolt | 22 N.m (16 lb ft) |
| Emission Reduction Fluid Tank Filler Pipe Bolt | 9 N.m (80 lb in) |
| Emission Reduction Fluid Tank Nut | 28 N.m (21 lb ft) |
| Emission Reduction Fluid Tank Protector Nut | 22 N.m (16 lb ft) |
| Engine Control Module Bracket Nut | 9 N.m (80 lb in) |
| Engine Coolant Temperature Sensor | 15 N.m (11 lb ft) |
| Exhaust Gas Recirculation Cooler Bolt @ Air Conditioning Compressor Bracket | 25 N.m (18 lb ft) |
| Exhaust Gas Recirculation Cooler Bolt @ Exhaust Gas Recirculation Valve Machined Housing | 15 N.m (11 lb ft) |
| Exhaust Gas Recirculation Cooler Bypass Valve Actuator Fastener | 9 N.m (80 lb in) |
| Exhaust Gas Recirculation Cooler Temperature Sensor | 45 N.m (33 lb ft) |
| Exhaust Gas Recirculation Manifold Brace Bolt | 58 N.m (43 lb ft) |
| Exhaust Gas Recirculation Pipe Fastener @ Exhaust Gas Recirculation Valve | 25 N.m (18 lb ft) |
| Exhaust Gas Recirculation Pipe Fastener @ Intake Manifold | 11 N.m (97 lb in) |
| Exhaust Gas Recirculation Valve Adapter Nut | 25 N.m (18 lb ft) |
| Exhaust Particulate Sensor | 50 N.m (37 lb ft) |
| Exhaust Particulate Sensor Fastener | 9 N.m (80 lb in) |
| Exhaust Pressure Differential Sensor Fastener | 7 N.m (62 lb in) |
| Exhaust Pressure Differential Sensor Nut | 45 N.m (33 lb ft) |
| Exhaust Pressure Differential Sensor Pipe Clamp Nut | 9 N.m (80 lb in) |
| Exhaust Temperature Sensor | 45 N.m (33 lb ft) |
| Flywheel and Crankshaft Position Sensor Access Cover Fastener | 10 N.m (89 lb in) |
| Fuel Feed Pipe Fastener | 15 N.m (11 lb ft) |
| Fuel Filter Cover | 20 N.m (15 lb ft) |
| Fuel Filter Fastener | 25 N.m (18 lb ft) |
| Fuel Filter Heater Bolt | 9 N.m (80 lb in) |
| Fuel Injection Fuel Rail Fastener | 25 N.m (18 lb ft) |
| Fuel Injection Fuel Rail Fuel Pressure Sensor | 35 N.m (26 lb ft) |
| Fuel Injection Pump Drive Pulley Retaining Nut | 88 N.m (65 lb ft) |
| Fuel Injection Pump Metering Valve Fastener | 9 N.m (80 lb in) |
| Fuel Injector Bracket Bolt | 32 N.m (24 lb ft) |
| Fuel Pipe Bracket Nut | 10N.m (89 lb in) |
| Fuel Pump Fuel Feed Hose Bolt | 58 N.m (43 lb ft) |
| Fuel Pump Fuel Return Hose Bolt | 22 N.m (16 lb ft) |
| Fuel Pump Nut | 25 N.m (18 lb ft) |
| Fuel Return Hose Bracket Bolt | 22 N.m (16 lb ft) |
| Fuel Tank Filler Hose Clamp | 3.5 N.m (31 lb in) |
| Fuel Tank Filler Pipe Bolt | 9 N.m (80 lb in) |
| Fuel Tank Filler Pipe Clamp | 3.5 N.m (31 lb in) |
| Fuel Tank Strap Bolt | 45 N.m (33 lb ft) |
| Glow Plug | 14 N.m (10 lb ft) |
| Intake Air Baffle Bolt | 1.5 N.m (13 lb in) |
| Intake Manifold Tuning Vacuum Control Solenoid Valve Bolt | 7 N.m (62 lb in) |
| Low Pressure Diesel Hydrocarbon Injector | 45 N.m (33 lb ft) |
| Low Pressure Diesel Hydrocarbon Injector Bolt | 9 N.m (80 lb in) |
| Mass Airflow Sensor with Intake Air Temperature Sensor Bolt | 1.5 N.m (13 lb in) |
| Nitrogen Oxides Sensor | 50 N.m (37 lb ft) |
| Nitrogen Oxides Sensor Fastener | 9 N.m (80 lb in) |
| Positive Crankcase Ventilation Tube Bolt | 9 N.m (80 lb in) |
| Throttle Body Assembly Fastener | 11 N.m (97 lb in) |
| Throttle Inlet Absolute Pressure Sensor Fastener | 9 N.m (80 lb in) |
| Vacuum Pump Pipe Bolt | 11 N.m (97 lb in) |