FixVault
Home › Chevrolet › 2020 › Traverse LS, 4WD › Repair and Diagnosis › Body & Frame › Body, Cab Control Systems › Vehicle Access System › Diagnostic Information and Procedures › Exterior Door Handle Switch Malfunction › Circuit/System Verification

Circuit/System Verification

  1. Ignition - On/Vehicle - In Service Mode
  2. Verify the scan tool parameter:
    • Exterior Driver Door Handle Switch = Inactive
    • Exterior Passenger Door Handle Switch = Inactive
    • Exterior Left Rear Door Handle Switch = Inactive
    • Exterior Right Rear Door Handle Switch = Inactive
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the component: B27D Door Handle Switch - Driver Exterior - Pressed

    Verify the scan tool parameter: Exterior Driver Door Handle Switch = Active

    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  4. Operate the component: B27P Door Handle Switch - Passenger Exterior - Pressed

    Verify the scan tool parameter: Exterior Passenger Door Handle Switch = Active

    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  5. Operate the component: B27LR Door Handle Switch - Left Rear Exterior - Pressed

    Verify the scan tool parameter: Exterior Left Rear Door Handle Switch = Active

    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  6. Operate the component: B27RR Door Handle Switch - Right Rear Exterior - Pressed

    Verify the scan tool parameter: Exterior Right Rear Door Handle Switch = Active

    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  7. All OK.
About FixVault