Removal Procedure

Raise and support the vehicle. Lifting and Jacking the Vehicle
Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The proper position of the underbody skid shield is between the underbody splash shield and the front frame.

Underbody Skid Shield Bolt (1) - Remove [2x]
Underbody Splash Shield Bolt (2) - Remove [2x]
Underbody Skid Shield (3) - Remove
Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod.
Courtesy of GENERAL MOTORS COMPANY

Steering Linkage Inner Tie Rod Nut (1) - Loosen
Courtesy of GENERAL MOTORS COMPANY

Steering Linkage Outer Tie Rod Nut (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.

Using CH-43631 Ball Joint Separator (1), remove the steering linkage outer tie rod from the steering knuckle.
Courtesy of GENERAL MOTORS COMPANY

Steering Linkage Outer Tie Rod (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Linkage Inner Tie Rod Nut (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Gear Boot Outer Clamp (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Gear Boot Inner Clamp (1) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY

Steering Gear Boot (1) - Remove