FixVault
Home › Chevrolet › 2021 › Traverse L › Repair and Diagnosis › External Pages › Different car › Section 55 (Antilock Brake System) › Diagnostic Information and Procedures › DTC C05D0 › Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify there are no related DTCs set in the following system:Stop Lamps
    • Go to next step: If the DTC is not set 
  2. Test or inspect for the following:Brake Pedal=Binding or Sticking

    Refer to:Brake System Slow Release

  3. Perform the scan tool control function: Brake Master Cylinder Pressure Test
    • If the procedure/test passes 
    1. Ignition/Vehicle - Off - For greater than 5 min
    2. Ignition/Vehicle - On - For greater than 60 s - Brake Pedal Not Applied
    3. Apply and hold the brake pedal.to half stroke - For greater than 2 s
    4. Slowly release the brake pedal.
    5. Verify DTC C05D0 is not set.
      • If the DTC sets

        Replace the component:A104 Brake Master Cylinder

      • Go to next step: If the DTC is not set
    6. All OK.
    • Go to next step: If the procedure/test does not pass 
  4. Bleed the brake system.Refer to:Automated Brake Bleed
  5. Perform the scan tool control function:Brake Hydraulics Test
    • If the procedure/test does not pass 
  6. Replace the component:A104 Brake Master Cylinder
    • Go to next step: If the procedure/test passes 
  7. Ignition/Vehicle - Off - For greater than 5 min
  8. Ignition/Vehicle - On - For greater than 60 s - Brake Pedal Not Applied
  9. Apply and hold the brake pedal.to half stroke - For greater than 2 s
  10. Slowly release the brake pedal.
  11. Verify DTC C05D0 is not set.
    • If the DTC sets 

      Replace the component:A104 Brake Master Cylinder

    • Go to next step: If the DTC is not set 
  12. All OK.
About FixVault