Removal Procedure
WARNING: This page is about a different car, the 2021 Chevrolet Tahoe and 2021 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the SIR system. SIR Disabling and Enabling
- Use a flat bladed trim tool to depress the steering wheel airbag access hole cover detents to remove the 2 steering wheel airbag access hole covers (1).NOTE:
Left side shown, right side similar.
- Steering Wheel Airbag Bolt (1) - Remove [2x]
- Release the connector position assurance (CPA) retainer.
- Disconnect the electrical connectors.
- Steering Wheel Airbag (2) - Remove
- Loosen the steering wheel bolt (1) so that 2 - 3 threads are engaged.
- Wiggle the steering wheel until the wheel disengages completely.
- Steering Wheel Bolt (1) - Remove
- Steering Wheel (2) - Remove
- Remove the 4 steering wheel spoke cover bolts (1).
- Remove the 4 steering wheel bolts (2).
- Steering Wheel Shroud (1) - Remove
- Disconnect the heated steering wheel module electrical connectors, if equipped.
- Disconnect the electrical connector.
- Radio Volume Switch (1) - Remove
- Disconnect the electrical connector.
- Radio Favorites Switch (1) - Remove
- Steering Wheel Spoke Cover Bolt (1) - Remove [2x]
- Steering Wheel Spoke Cover (1) - Remove
- Disconnect the electrical connectors.
- Steering Wheel Bolt (1) @Cruise Control Switch - Remove [3x]
- Cruise Control Release Switch Bracket (1) - Remove
- Cruise Control Switch (1) - Remove