FixVault
Home › Chevrolet › 2022 › Tahoe SSV › Repair and Diagnosis › Steering › Steering Column › Steering Wheel And Column › Repair Instructions › Steering Wheel Replacement › Installation Procedure

Installation Procedure

  1. GM5525860Courtesy of GENERAL MOTORS COMPANY

    Steering Wheel (2) - Install

  2. If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
    1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
    2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Remove loose debris from internal and external threads using compressed air.
    4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation. Adhesives, Fluids, Lubricants, and Sealers 
    3. CAUTION:

    Fastener Caution

  3. Steering Wheel Bolt (1) - Install and tighten - Fastener Specifications 
  4. GM5525856Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connectors.

  5. Install any connector position assurance (CPA) devices or secondary locks.
  6. Steering Wheel Airbag (2) - Install
  7. Steering Wheel Airbag Bolt (1) - Install and tighten [2x] - Fastener Specifications
  8. GM5520780Courtesy of GENERAL MOTORS COMPANY

    Install the 2 steering wheel airbag access hole covers (1).

  9. Enable the SIR System. SIR Disabling and Enabling
About FixVault