Circuit/System Verification

C0460 4B

1. Ignition - On/Vehicle - In Service Mode
2. Verify DTC C0460 4B is not set.
   • If the DTC is set 
   1. Perform the following procedure/test: Power Steering Control Module Calibration 
   2. Verify the DTC does not set.
      • If the DTC sets - Replace the component: Steering Column
      • Go to next step: If the DTC is not set
   3. All OK.
   • Go to next step: If the DTC is not set 
3. All OK.

C0460 58

NOTE:

Inspect the electrical connectors and the ground circuits of the component for poor connections.

2. Ignition - On/Vehicle - In Service Mode
3. Verify DTC C0460 58 is not set.
   • If the DTC is set 

     Replace the component: Steering Column

   • Go to next step: If the DTC is not set 
4. Ignition/Vehicle - On
5. Rotate the steering wheel from left to right.Verify the scan tool parameter: Steering Wheel Angle - IncreaseorDecrease
   • If the parameter value does not change

     Replace the component: Steering Column

   • Go to next step: If the parameter value changes
6. All OK.

C0460 5A

1. Ignition - On/Vehicle - In Service Mode
2. Verify DTC C0460 5A is not set.
   • If the DTC is set 
   1. Verify the following conditions do not exist: Front wheel alignment - Incorrect adjustment - Refer to: Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
   2. Verify the scan tool parameter: Steering Wheel Angle = 0 degrees
      • If not 0° 
   3. Perform the following procedure/test: Power Steering Control Module Calibration 
   4. Verify the DTC does not set.
      • If the DTC sets - Replace the component: Steering Column
      • Go to next step: If the DTC does not set
   5. All OK.
   • Go to next step: If 0° 
3. All OK.