Programming an Existing or New Control Module

To program an existing or new control module, perform the following procedure:

1. Install the special tool: EL-49642 SPS Programming Support Tool
2. Ignition Off
3. Access SPS and follow the on-screen instructions for the control module:Select - Q8 Control Solenoid Valve AssemblyorK71 Transmission Control Module
   1. Select - Programming
   2. Ignition/Vehicle - Off - For greater than 2 min
   3. Select - Setup - Follow the on-screen instructions.
4. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
5. All OK.