Programming an Existing or New Control Module

WARNING: This page is about a different variant/trim than selected.

To program an existing or new control module, perform the following procedure:

Ignition/Vehicle OFF, ensure that the key fob is inside the vehicle and not moved for the duration of the programming.
Access the Service Programming System (SPS) and follow the on-screen instructions for the K160 Brake System Control Module.
Perform the SPS function: Prepare Control Module for Removal and follow the on-screen instructions.
Perform the SPS function: Programming and follow the on-screen instructions.
Perform the SPS function: Setup and follow the on-screen instructions.
Clear DTCs.