FixVault
Home › Chevrolet › 2024 › Traverse LS, 4WD › Repair and Diagnosis › General Information › Reset Procedures › Programming And Setup › Repair Instructions › K73 Telematics Communication Interface Control Module: Programming and Setup (UE1) › Programming Control Module for an Update

Programming Control Module for an Update

To program an existing control module for an update, perform the following procedure:

NOTE:

Begin with the vehicle in the vehicle OFF power mode. The Service Programming System will power mode the vehicle.

  1. Ignition / Vehicle OFF.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. Check and follow Preliminary Information or Technical Service Bulletins before programming. If control module software updates are available, in the SPS Supported Controllers screen, select K73 - Software Update and follow the on-screen instructions.
    NOTE:

    For programming an existing module, you only need to perform "Software Update".

  4. Clear DTCs.
About FixVault