Circuit/System Verification

1. Vehicle Power Mode state - Service/Run  .
2. Verify DTC P0D5C is not set
   • If the DTC sets 
   • Replace the component: T18 Battery Charger
   • Go to next step: If the DTC is not set 
3. All OK.

Repair Instructions

• Perform the Diagnostic Repair Verification after completing the repair.
• Drive Motor Power Distribution Control Module Replacement (XRD & K28) , or Drive Motor Power Distribution Control Module Replacement (FWD & K28) , or Drive Motor Power Distribution Control Module Replacement (FWD & K2O/K2W) , or Drive Motor Power Distribution Control Module Replacement (XRD & K2O/K2W) - T18 Battery Charger
• If necessary, perform the following steps: Control Module References for T18 Battery Charger replacement, programming, and setup.