Installation Procedure
Remote Function Actuator Module (1) - Install
- Connect the electrical connector.
- Quarter Lower Rear Trim Panel - Right Side (1) - Install
- CAUTION:
Refer to Fastener Caution .
Body Lock Pillar Lower Trim Panel Bolt - Right Side (2) - Install and tighten - Fastener Specifications
- Quarter Trim Panel Cover - Right Side (1) - Install
Cargo Tie Down Loop - Right Side (3) - Install
- If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
- Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
- Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
- Remove loose debris from internal and external threads using compressed air.
- Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation. Adhesives, Fluids, Lubricants, and Sealers
- Cargo Tie Down Loop Bolt - Right Side (2) - Install and tighten - Fastener Specifications
- Cargo Tie Down Loop Bolt Cap - Right Side (1) - Install
Convenience Net Retainer - Right Side (1) - Install and tighten - Fastener Specifications
Liftgate Sill Garnish Molding (2) - Install
- Liftgate Lock Striker Cover (1) - Install
Rear Compartment Floor Stowage Compartment Divider (2) - Install
- Rear Compartment Floor Stowage Compartment Divider Retainer (1) - Install and tighten [4x] - Fastener Specifications
Load Floor Stowage Compartment Cover (1) - Install
Quarter Window Trim Finish Panel - Right Side (1) - Install
Quarter Window Trim Finish Panel Bolt - Right Side (1) - Install and tighten - Fastener Specifications
- Quarter Window Trim Finish Panel Bolt Cap - Right Side (2) - Install
Rear Seat Shoulder Belt Guide - Right Side (1) - Install
Rear Side Door Sill Garnish Molding - Right Side (1) - Install
Rear Seat Back Cushion - Right Side (3) - Install - Rear Seat Back Cushion Removal and Installation - Right Side
- Enable the SIR System. SIR Disabling and Enabling