FixVault
Home › Chevrolet › 2025 › Tahoe SSV › Repair and Diagnosis › General Information › Reset Procedures › Programming And Setup - All Systems › Repair Instructions › K73 Telematic Control Module: Programming and Setup (UE1 with CZ2) › Programming Control Module for an Update

Programming Control Module for an Update

To program an existing control module for an update, perform the following procedure:

NOTE:

Begin with the vehicle in the vehicle OFF power mode. The Service Programming System will power mode the vehicle.

NOTE:

For successful programming the correct order MUST be followed: Prepare for Software Update then Software Update.

  1. Ignition/Vehicle OFF.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K73 Telematic Control Module - Prepare for Software Update
  4. Check and follow Preliminary Information or Technical Service Bulletins before programming. If control module software updates are available, in the SPS Supported Controllers screen, select K73 Telematic Control Module - Software Update and follow the on-screen instructions.
    NOTE:

    Refer to and follow the Preliminary Information or Service Bulletin to successfully program this control module.

  5. Clear DTCs.
About FixVault