Programming an Existing Control Module

Perform all necessary programming and setup procedures for the control module: K45 Powertrain Control Module

1. Ignition - On/Vehicle - In Service Mode
2. Access SPS and follow the on-screen instructions for the control module: K45 Powertrain Control Module
3. Perform the necessary programming and setup procedure:
   • Select: Refresh Characterization Data
   • Select: Replace - Control Valve Body
   • Select: Replace - Transmission
4. Perform the scan tool function: Clear DTCs
5. Perform the scan tool configuration/reset function:
   • Configuration/Reset Functions - Engine - If applicable
   • Configuration/Reset Functions - Transmission - If applicable
6. Perform the scan tool function: Clear DTCs