FixVault
Home › Chevrolet › 2025 › Trax LS › Repair and Diagnosis › Steering › Steering Column › Steering Wheel And Column › Repair Instructions › Turn Signal Switch Bracket Replacement (BTM) › Installation Procedure

Installation Procedure

  1. GM5927720Courtesy of GENERAL MOTORS COMPANY

    Turn Signal Switch Bracket (1) - Install

  2. GM5927719Courtesy of GENERAL MOTORS COMPANY

    Turn Signal Switch (1) @ Turn Signal Switch Bracket - Install

  3. Windshield Wiper and Washer Switch (2) @ Turn Signal Switch Bracket - Install
  4. Secure the retaining tabs.
  5. GM5913314Courtesy of GENERAL MOTORS COMPANY

    Ensure the steering wheel airbag coil (1) is CENTERED during installation. Steering Wheel Airbag Coil Centering

  6. Steering Wheel Airbag Coil (1) - Install
  7. Connect the electrical connector.
  8. GM5913311Courtesy of GENERAL MOTORS COMPANY

    Steering Wheel (2) - Install

  9. If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
    1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
    2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Remove loose debris from internal and external threads using compressed air.
    4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation. Adhesives, Fluids, Lubricants, and Sealers (except GMNA) , or Adhesives, Fluids, Lubricants, and Sealers (GMNA) 
  10. Connect the electrical connector.
    11. CAUTION:

    Fastener Caution

  11. Steering Wheel Bolt (1) - Install and tighten - Fastener Specifications 
  12. GM5913309Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector.

  13. Install any connector position assurance (CPA) devices or secondary locks.
  14. Steering Wheel Airbag (2) - Install
  15. Steering Wheel Airbag Bolt (1) Install and tighten [2x] - Fastener Specifications
  16. GM5913305Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Install the 2 steering wheel airbag access hole covers (1).

  17. GM5910478Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Steering Column Lower Trim Cover (2) - Install

  18. Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Install and tighten [3x] - Fastener Specifications
  19. GM5910455Courtesy of GENERAL MOTORS COMPANY

    Secure the instrument panel steering column upper trim cover (1) to the instrument panel steering column lower trim cover in the opposite direction of the arrow.

  20. Enable the SIR System. SIR Disabling and Enabling
About FixVault