FixVault
Home › Chrysler › 1982 › Cordoba Base, 3.7L Eng VIN F › Repair and Diagnosis › Engine Performance › Ignition System › Electronic Ignition › Testing › Dual Pick-Up Start-Run Relay

Dual Pick-Up Start-Run Relay

  1. Turn ignition switch "OFF". Remove 2-wire connector from dual pick-up start-run relay terminals 4 and 5. Using an ohmmeter, connect leads to terminals 4 and 5 of relay. See Fig 1.
  2. Resistance reading should be 20-30 ohms. If not to specification, replace start-run relay.
    Fig 1: Dual Pick-Up Start-Run Relay Terminal Locations
    G09316107Courtesy of CHRYSLER GROUP, LLC
About FixVault