Electronic Ignition: Testing: Notes

NOTE: If a suitable tester (C-4166 with adapter C-4166-1 or C-4166-A, or tester C-4503 with adapter C-4503-3) is available, use tester and follow manufacturer's instructions. If tester is not available, proceed as follows:

Check that all secondary cables, primary wire at coil and ballast resistor are not excessively loose or cracked. Use a voltmeter with a 20, 000 ohm/Volt rating and an ohmmeter that uses a 9 volt battery for its operation. Check calibration of both meters. Check and record battery voltage reading using a voltmeter. Proceed with following tests.

CAUTION: When removing or installing wiring connector, ignition switch must be in "OFF" position.