RWD Models
- Connect test light between ground and Brown/Red wire at servo terminal. See Fig 1
. With ignition and cruise control switch in "ON" position, test light should glow. Push "SET" button. Test light should go out and a click should be heard at servo.
- Release "SET" button. Test light should come on and another click should be heard at servo. If test light does not come on, check for blown fuse, faulty wiring or defective switch. If no clicks are heard, replace servo.
- Connect test light between ground and White/Red wire at servo terminal. With ignition switch and cruise control switch in "ON" position, test light should be off. Push "SET" button. Test light should come on. If test light does not respond properly, check for defective switch or faulty wiring.
- Connect test light between ground and Blue/Red wire at servo terminal. With ignition and cruise control switch in "ON" position, test light should come on. If not, check for faulty wiring, brake switch, clutch switch or cruise control switch.
Courtesy of CHRYSLER MOTORS.