Memory Seat Self-Test

Press memory switches "1" and "2" and hold for between 5-10 seconds to enter switch self-test mode.

• Three seconds after releasing switches, control module should move seat to a mid-travel position.
• Within 10 seconds, move seat switch to activate a seat motor. Check for seat movement in all switch positions: seat track forward, rearward, front upward and front downward.
• With 10 seconds of last seat movement, press memory switches "1" and "2" for at least 5 seconds and release. Seat should move to a full downward and rearward position. Module should move seat until it comes to a stall in 8 positions: forward, rearward, front up, front down, rear up, rear down, recliner forward and recliner downward.
• If a problem exists, control module will not move seat for that function.
• After all motors have run to stall, the system will pause for 3 seconds, then return to mid-travel position. Control module will move seat through its positions for a 2 second run.
• If a problem is found, control module will go into a loop and move only problem part of system.
• To exit loop, press "SET," "1" or "2" buttons to repair fault. When seat stops, system will return to normal operating mode.
• If a problem is found, see TROUBLE SHOOTING  .