Servo Unit
- Turn ignition and cruise control switch to ON position. Disconnect 4-wire servo connector. See Fig 1
. Connect voltmeter to pin No. 2 of main harness connector. Voltmeter should read battery voltage. If not, check for loose connections or wiring harness.
Courtesy of CHRYSLER MOTORS.
- Connect jumper wire between male and female terminals of pin No. 2. Check voltage to the other 3 male terminals from servo. Voltmeter should read battery voltage at all terminals. If not, replace servo.
- Using an ohmmeter, connect one lead to ground. Connect other lead to pin No. 1 of wire harness connector. Ohmmeter should read continuity. If no continuity is present, repair ground circuit.