FixVault
Home › Chrysler › 1993 › Imperial › Repair and Diagnosis › Engine Performance › System › Engine Controls - Tests W/Codes - Body Control Computer › Self-Diagnostic Tests › Test 30A - Right BRAKELIGHTS Out

Test 30A - Right BRAKELIGHTS Out

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Disconnect multifunction switch 24-pin connector. See Figure . Connect jumper wire between terminal No. 14 (White/Tan) and terminalNo. 12 (Brown/Red wire) of multifunction switch 24-pin connector. Depress brake pedal. If right side brakelights are on, replace multifunction switch. Perform VERIFICATION PROCEDURE VER-1.
  2. If right side brakelights are off, disconnect jumper wire. Reconnect multifunction switch 24-pin connector. Disconnect light outage module 14-pin connector. See Figure . Check connector condition, and clean or repair connector as necessary. Connect jumper wire between terminal No. 8 (Brown/Red wire) and terminal No. 9 (Brown wire) of light outage module 14-pin connector.
  3. Depress brake pedal. If one right side brakelight comes on, replace light outage module. Perform VERIFICATION PROCEDURE VER-1. If one right side brakelight does not come on, repair open Brown/Red wire. Perform VERIFICATION PROCEDURE VER-1.
About FixVault